![]() Some of the hardware require you to go to control panel. Incase it is not plug and play the hardware do come with installation CD with it which should be inserted at CD ROM so as to detect hardware ![]() When fixing hardware to the computer if it is plug and play it has its setting already with it hence the computer will be able to detect it and it shall be available for use. The BIOS Setup utility can be accessed by pressing the F10 key to save the changes. You can confirm the changes by highlighting OK, then pressing Enter. The factory default settings can be loaded by pressing the F9 key. Ensure that also the hardware is properly connected such that it has power and the cable to the motherboard are fixed properly. How Do I Force BIOS To Reset You can access the BIOS Setup utility by going to Accessing BIOS. When booting from the CD ROM ensure that the set up disk is already available in the CD ROM. When booting from hard disk ensure that the set up is already installed in the computer. So when in the BIO set up you must direct your computer to boot from either of the above. This information normally come from either the hard disk or the CD ROM ( Compact Disk Read Only Memory). When computer is booting it has to have the source of the information. How can I reset CMOS and BIOS settings of dell optiplex 740?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |